Solenoid Operated Poppet Type Two-Way Valves

　　These valves are used for opening/closing the oil path by having the poppet valve operated with an electric signal via solenoid. Because these are of poppet type, the internal leakage is quite small and there is no worry about hydraulic lock.

Graphic Symbol

　　一、Specifications

　　1. The maximum flow means the limited flow without inducing any abnormality to the operation (changeover) of the valve.

　　2. When the valve is operated at 18.5 Mpa (2680 PSI) or higher pressure, continuous energies time is restricted with Max. 30 min., and also the energies ratio less than 90 %.

　　二、Solenoid Ratings

　　1. Because both AC and DC solenoids employ the plug-in type electrical wiring, the valve can be removed without removing the wiring. (Coil type of CDSC-01 is flying lead wire only.)

　　2. Being 50-60 Hz common service AC solenoids, do not require rewiring when the applied frequency is changed.

　　3. K-Series DC Solenoid which has a reputation for excellent DC control is employed. (Coil type of CDSC-01 is with Surge Suppressor.)

　　三、Model Number Designation

　　Special seals (Viton seals) are required when phosphate ester type fluids are used. (Prefix "F-" to the model numbers when ordering.)

　　Instructions：

　　1. Direction of flow when the solenoid is energised

　　2. These valves do not allow flow from Y to X when the solenoid is energised.

　　3. the time of test run, there is a possibility that the oil may not flow even after the solenoid is energised because of the residual air in the valve.

　　4. Mounting

　　There are no mounting restrictions for any models.

　　Notes: Please call our company telephone 021-67687301, 67687302 to buy "Solenoid Operated Poppet Type Two-Way Valves" products. Browse this webpage carefully to know more about Solenoid Operated Poppet Type Two-Way Valves.